When “LF” is displayed, there could be an issue with the water flowing into the machine.
Disconnect the water inflow connection and see if the is a small screen filter that has clogged up and clean it out.
Robert Baca The error code LF stands for Long Fill. This could be due to a blockage in your water supply. Remove the hoses from the back of your washer and take a look at the flow by opening the individual faucets and run water into a bucket. If that looks about normal, check the back of the water inlet valves. There are commonly some screens that act as filters. If those are clogged, you can replace the screens by simply pulling them out with a pair of needle nose players. If none of that shows the desired effect, consider replacing the water inlet valves since they maybe partially blocked. Let us know what you find out. You can always post pictures of what you see with your QUESTION. Adding s to an existing question
Checking Water Inlet Filters
The water to your machine must be shut off before you check the water inlet valves and filters. Go ahead and turn off the water to the washer by turning the hot and cold taps off.
Now, you can disconnect the water inlet hoses. Look at where they are connected to your washing machine and disconnect one. There will be a rubber gasket at the top of the valve. Remove that and clean it. Then, you will see a screen.
You should be able to remove the screen to clean them. Wash under cool, running tap water. The grime may be hardened, which may require you to scrape it off. Be careful so you don’t damage the filter.
# What LF mean on your Maytag washer
So, what does LF mean on my Maytag washer? If you have recently seen the error code F8 E1 or LF / LO error, it means that there is no water entering the washer for 13 minutes or more. If you could see one of these error codes depending on the washer model, you must know the user’s manual for troubleshooting. If the error code F8 E1 or LF shows on display, the doors of your washer will be locked, and the controls of the washer will become unresponsive. You will need to press the power button to make the washer do its draining routine to troubleshoot the problem.
The draining will take approximately 8 to 10 minutes of your time. While draining, the pump will run continuously, and any controls will be unresponsive. After the given time, try not to do any functions but wait before trying the other features.
You probably have used the washer thinking that the water source is turned on. Check both the hot and cold water faucets to make sure that both sources are working. The washer won’t work unless both the hot and cold water sources are supplied. Next is to remove the error code.
To do this, you’ll have to press the power button to restart the washer. If the power button does not work, try disconnecting and reconnecting the power plug. Reselect the cycle to start. If the washer is newly purchased, it is normal for one of these error codes to appear. Once you push the power button, the washer will start to drain, and all of the other buttons will become unresponsive.
Can I put an anti-flood control or device on my washer?
Maytag experts state this isn’t a good idea because it could interfere with water properly flowing into your washer within the correct time programmed on the washer’s control panel.
FAQ
What does low FL mean on Maytag washer?
How do you clear the LF code on a Whirlpool washer?
What is LF error code?
How do I reset my Maytag washer?